Leaderboard

Hi Everyone! I'm sorry for creating this thread but after reading some topics I've found that somebody has any troubles with installing XPenology on Proxmox. This also concerns me - I have a trouble with 6.2 on my Microserver Gen 8 with Proxmox on it - no network devices. So, after some attempts I have a success with 6.2 DSM with 3615xs and 3617xs only with 6.2_23739 with manual Installation. After fresh install I make a full backup, so this can be used as template. There are 6.1 and 6.2 of DSM version. So, You just need to copy this backup to Your Backup Directory in Proxmox and Restore it. 3615xs and 3617xs has successfully tested on HP MicroServer Gen 8 / Proxmox 5.3.5 | 5.3.6! DS918 was successfully installed on SuperMicro SYS-1029P-WT with Intel Xeon Silver 4110. I've decided to publish it to for everybody too. Download Link --------------->>>>> MEGA.CO.NZ There are some several important points: TWO Network Interfaces. First NIC is disabled. It has been done because for DSM first device must be with suitable MAC which is fixed in Grub. If You need multiple instance of DSM (as me) - it's costly to mofidy everytime Grub. So Second NIC uses any MAC address from Proxmox. TWO Disk Drives. Firsk disk - is bootable disk made by Jun! Don't try to use is as Storage. (maybe it's painfully, I haven't checked). Second Drive - it's a System Drive where was DSM has already installed. Second drive capacity - 6 GB! For me it's suitable - I use free capacity 1.3 GB only for Software and another drive for everything. If You need more for System Drive - Just Resize Disk before first start/initialization. I have tested that there is no errors after resizing before first initialization. Boot Drive - Sata0.

should also be fine with 6.2.3 when the new extra for 6.2.3 is used https://xpenology.com/forum/topic/28321-driver-extension-jun-103b104b-for-dsm623-for-918-3615xs-3617xs/ when the system is up you would remove the usb (its only mounted when booting), replace the extra.lzma, put the usb back in and then update normally with the webgui to 6.2.3 (it will be 2 steps/reboots as there is already a u3 for 6.2.3)

Happy New Year. Just want to report back that everything has worked perfectly fine. I renewed the Usb Stick like flyride told, moved all Drives and added some new, booted with the fresh Stick, installed new DSM version. Little nervous while the Webservice told me i can't login because "System is getting ready" but it rebooted again and i was able to log in. ig88 I am not really sure what you wrote about rd.gz but thank you also. Runs like a beast, just happy.

Je suppose que tu as vérifié que le pb ne venait pas du câble avant de l'incriminer ? Et en effet il est à ce jour préférable de disposer d'une carte réseau à base de chipset Intel, maintenant si tu en trouves une regarde directement dans la section suivante https://xpenology.com/forum/forum/78-dsm-updates-reporting/ si quelqu'un l'a.

Hello, De manière général il faut privilégier ceux avec un chipset Intel. Il le semble avoir vu je ne sais plus où un topic qui fait un listing des cartes réseaux testées.