Rescue Console or something?

[SerpensAlatus]

Hi,

 

today my NAS won't start anymore. It boots but stops before there is a network connection.

 

Is there a console or something so that i can where it stucks?

 

I use Junes Bootloader 1.04b für the 918+

 

Thanks in advance

 

Serpens.

[bearcat]

@SerpensAlatus did you by any chance update your NAS?

[SerpensAlatus]

Maybe. I restarted the NAS and it was dead. 

You think about Problems with the NIC, right ? 

 

Regards

Volker

 

[jensmander]

In most cases this happens when you haven’t disabled the automatic installation of updates. If you have a s-ata port left you could try the following:

 

- shut down your nas

- unplug your current drives

- if you have different drive sizes write down which drive is connected to each s-ata port

- add a blank hdd to your free port

- power up the nas and do a fresh install on the blank hdd, follow the initial setup and shut the nas down once it’s complete

- reconnect your old drives and start the system again, you should see your raid/volumes now again

 

Or you can add an additional NIC (Intel) which is supported by the 918+ loader.