Hi, are you using a nfs share?
Hi, if you have the acpid addon activated it works (default is on).
If you have done a clean install of dsm, you need to reboot it manually, after this it works too.
@Green
Probably the loader you have is too old.
With the new loader the arpl-reboot.sh is included. Not needed for download.
You need to manually Update to the new loader, than it should work.
Reboot your system, ob boot in grub select Configure Loader. Now can Upgrade to the new loader.
Your Synology User does not have write permission on that folder.
You need to "cd" to a folder with permission (e.g. /volume1/homes/...) or use the sudo for the wget command too.
sudo wget https://raw.githubusercontent.com/fbelavenuto/arpl/main/files/board/arpl/overlayfs/usr/sbin/arpl-reboot.sh
sudo arpl-reboot.sh config
q35 is only need if you passthrough pci devices.
I don't think there is so much different between sata and scsi on virtual Drives.
It works with q35 too, my mistake was that i have limited the disks to 6 drives in arpl. I have change it to 12 and now q35 with 6 sata drives works too.
I think you should test it.
Sorry I use DS3622. I test it with 918 now.
In my config I use i440fx, rest same.
@Kyar
if you don't need more than 6 virtual Drives, you can use SATA instead SCSI and if440fx instead q35, so it works on my test setup with 6 Drives.
@SanKen
you can change the MAC Adress:
@fbelavenuto
Thank you very much for your hard work. Best tool ever.
@Kyar
i have added 4 virtual SCSI Drives in Proxmox and startet the VM and all are working, Volume create...
What SCSI Controller do you use or do you use Passthrough Drives?