rsauw Posted November 27, 2017 Share #1 Posted November 27, 2017 Hello, I'm trying to setup a nas on a HP proliant ML350 with 6.0.2 and it is working but i want to connect the embedded raid to the nas to but the nas for some reason doesn't see the embedded raid. How can i fix that? Thanks for the help. Quote Link to comment Share on other sites More sharing options...
0 sbv3000 Posted November 27, 2017 Share #2 Posted November 27, 2017 You will probably need to set the raid controller to 'non-raid', 'jbod' or 'passthrough' (which ever is applicable terms for the setup) then you create a raid in DSM. I think the on board raid is adaptec, check the drivers in 6.0.2 as you might need to use the additional extra.lzma file from @IG-88 Quote Link to comment Share on other sites More sharing options...
0 rsauw Posted November 27, 2017 Author Share #3 Posted November 27, 2017 3 hours ago, sbv3000 said: You will probably need to set the raid controller to 'non-raid', 'jbod' or 'passthrough' (which ever is applicable terms for the setup) then you create a raid in DSM. I think the on board raid is adaptec, check the drivers in 6.0.2 as you might need to use the additional extra.lzma file from @IG-88 i have been looking for the file that you said i needed but i can't seen to find it (mabey i'm just looking in the wrong place). i have looked by @IG-88. Quote Link to comment Share on other sites More sharing options...
0 rsauw Posted November 27, 2017 Author Share #4 Posted November 27, 2017 I just found it and thank you for your help. Quote Link to comment Share on other sites More sharing options...
0 drogi Posted April 23, 2018 Share #5 Posted April 23, 2018 On 11/27/2017 at 4:29 PM, rsauw said: I just found it and thank you for your help. Hi rsauw, I'm trying to make it running on HP ML350 G5, but without success. First I was trying with integrated Smart Array E200i Controller, but no drives was visible, then I bought for this reason P410 raid card and the result was the same. Still no drives visible in DSM. Can you please give me any advice? For example what version did you used, any special settings, etc. Many thanks Quote Link to comment Share on other sites More sharing options...
Question
rsauw
Hello,
I'm trying to setup a nas on a HP proliant ML350 with 6.0.2 and it is working but i want to connect the embedded raid to the nas to but the nas for some reason doesn't see the embedded raid. How can i fix that?
Thanks for the help.
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.