kaku Posted December 16, 2022 Share #1 Posted December 16, 2022 I posted this is ARPL thread, but i think i should post here. I am trying to upgrade my hardware and shift my drives to it. its a B660 chipset board with i5 12400 CPU. I used the SAME SN and mac as before (DS3622xs+) as old HW on (TCRP DSM 7.1 4661 )It has 2 Volumes Volume 1 main (RAID 5 with all packages, 3 Disk)Volume 2 (1 DISK )I have successfully Loaded the latest ARPL. Issue is if I Connect Volume 2 (1 DISK to system ) . it boots ok. But if Both volumes are connected (3 + 1 disk ), I get no boot ( no IP).I have connected Vol2 (1 Disk) to all SATA ports one-by-one to check if any port issues, but they all are ok. Something in main Volume1 is giving boot issues. If i HOTPLUG the volume1 disk while DSM is running, the volume gets detected and i can assemble them, and "rapair" all packages. I dont know, where to start to solve this issue. how can certain packages force a No BOOT? Sent from my SM-G998B using Tapatalk Quote Link to comment Share on other sites More sharing options...
kaku Posted December 16, 2022 Author Share #2 Posted December 16, 2022 Ok so reinstalling DSM also didnt work. Data is intact but still volume1 disks will not let me boot if plugged in!Sent from my SM-G998B using Tapatalk Quote Link to comment Share on other sites More sharing options...
Peter Suh Posted December 16, 2022 Share #3 Posted December 16, 2022 Are you able to boot with only Volume 1? Was Volume 1 the first volume you installed Synology DSM on? If so, the package is probably installed in Volume 1. I don't know why the main system partition used to operate around Volume 1, but it seems to have moved to Volume 2. Volume 2 became the main system partition If Volume 1 is added in the process, system partition synchronization will be induced through Volume 2 and recovery. In this process, all packages of Volume 1 are expected to be initialized. If all my scenarios are correct, I recommend that you try to restore the system partition and packages using only Volume 1, excluding Volume 2, which was added later. Quote Link to comment Share on other sites More sharing options...
kaku Posted December 16, 2022 Author Share #4 Posted December 16, 2022 Yes, volume1 had all the packages abd was the first pool.DSM dont boot if Using only volume1 disk . No IP but led blinks.Using ONLY Volume2, DSM boots.Now if i connect disks of volime1 while DSM IS running then all packages are displayed and are marked to repair. I do all the package repair, and then reboot. Then again DSM FAILS TO boot (no ip) led blinksVolume1 cannot be in system at boot.Also I did a reinstall of DSM ON BOTH volumes by adding all drives(vol1 &vol2) AFTER the dsm booted and showed no drives error. It went ok . But on reboot again no IP.Sent from my SM-G998B using Tapatalk Quote Link to comment Share on other sites More sharing options...
kaku Posted December 16, 2022 Author Share #5 Posted December 16, 2022 Now I went back to TCRP and using fresh serial. Now atleast DSM boots. But now i am in a recoverable loop. Any idea how to get out of it?Sent from my SM-G998B using Tapatalk Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.