Jump to content
XPEnology Community

UPS support on DSM 4.2 Broken?


Recommended Posts

I'm trying to figure this problem out.

By using SSH, I do #cat/prop/bus/usb/devices

However it doesn't show anything look like a UPS

all it shows are USB-HUB(Which is on the motherboard) and mass storage (which is the DOM disk)

Now I'm wondering if the module that used to change USB device to ESATA device caused this.

I'll try find the original module file and cover it back, see what happens.

Link to comment
Share on other sites

OK then I guess it's not that simple. I've limited knowledge on Linux, I've tried to configure ups.conf but no luck

The problem is Linux didn't even pick up the device, I try my USB mouse, fail as well. Only USB storage can be recognized from what I can tell.


Can someone dig a bit deeper? thanks a lot.

Link to comment
Share on other sites

  • Create New...