xp_1409

has anyone tried to install 6.2.3 on a ASRock Z490M-ITX/AC ? ( or similar z490 mini itx board ) i hope to install xpenology on this board with a pentium g6500 or i3 with 3 x 4tb and two nvme ssd cache and a 10gb nic thanks in advance

hi i have attached the dsemg.file thanks eric dmesg

hi i have searched and found this in ethtool.eth2.result Settings for eth2: Supported ports: [ TP ] Supported link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full Supported pause frame use: Symmetric Supports auto-negotiation: Yes Advertised link modes: 100baseT/Full 1000baseT/Full 10000baseT/Full Advertised pause frame use: Symmetric Advertised auto-negotiation: Yes Speed: Unknown! Duplex: Full Port: Twisted Pair PHYAD: 0 Transceiver: external Auto-negotiation: on MDI-X: Unknown Supports Wake-on: g Wake-on: d Link detected: no and this in ethtool_info.eth2.result driver: atlantic version: 2.0.10.0 firmware-version: 3.1.30 bus-info: 0000:01:00.0 supports-statistics: yes supports-test: no supports-eeprom-access: no supports-register-dump: yes supports-priv-flags: no if you want more info let me know which files thanks eric

thanks installed 0.11 with date 29/04/20 as explained in 1st page but DSM does not recognised my synnology E10G18T1 DSM 25426 DS918+ on z370 and g5400 what am i doing wrong ? thanks eric

hi IG88 where can i download 0.11.2 ? checked the 0.11 file but data was 29/04/20 thanks eric

hello i used jun loader 1.04 and 918+ 23739.pat file everthing works ok but the speed is a little low about 70-80mb copy speed. my last nas with dsm 5.2 gets 112mb on the same network if i use jun loader 1.04 with 23739 from the 3617xs pat file can i get better speed ? thanks eric

hi i am building a new nas for replacement of the old 5.2. i have mb j4205 and downloaded jun loaeder 1.04. replaced mac adress, pin and vid for usb and lan card. must the serialnummber replaced with ? xpenologyserial generator has only serial for 3615, 3617 and 916+ or can i use the serial number mentioned in grub thanks eric