Jump to content
XPEnology Community

HP smart array e200 proliant ml150 g5

Recommended Posts

i dont think XPE 6 has the HP drivers included


But the array controllers I have used on XPE/DSM normally have to be set to JBOD or IT (Initiator Target) mode, or whatever is the 'non-raid' option and if the controller chipset is supported then it will see the drives.


I found this article that says that the e200 cannot be set to jbod :( but you can create separate single drive arrays




you could try newer firmware to see if jbod is available


Your other options could be to use the onboard sata (if the mobo has them) and set to non-raid, or install a compatible jbod controller



Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...