TCRP Question - NVMe and Proxmox vs. baremetal

[bas1212]

Hi all,

I wanted to install dsm on proxmox but I got confused and tried to switch to baremetal.

I need some advice. I tried to install xpenology with redpill tcrp loader on baremetal , but after creating the bootloader , the synology was not found.
rploader satamap says no warning and shows 6 ports and 4 drives. I also have 4 drives plugged in and 1 nvme drive.
So I tried to install on proxmox but now I get errors when installing,

I have enabled hotplug for the sata ports.but where im a bit confused is that I have an nvme disk that I cannot disable. I have installed proxmox on that and I can see the 4 other disks.
But If I called correctly I cannot install DSM on an nvme drive?

If I want to install DSM on baremetal should I remove the nvme drive? and try the red pill loader again?

This is my config for baremetal.

tc@box:~$ ./rploader.sh identifyusb
Found SanDisk Ultra SerialNumber: 4C531001330818121533
Vendor ID : 0x0781 Product ID : 0x5591
Should i update the user_config.json with these values ? [Yy/Nn]
Y
tc@box:~$ ./rploader.sh serialgen DS918+
Serial Number for Model = 1780PDN016484
Mac Address for Model DS918+ = 00:11:32:7F:F8:7A
Should i update the user_config.json with these values ? [Yy/Nn]
Y
tc@box:~$ vi user_config.json
tc@box:~$ ./rploader.sh satamap

Found "00:17.0 Intel Corporation Device 43d2 (rev 11)"
Detected 6 ports/4 drives. Override # of ports or ENTER to accept <6>

Computed settings:
SataPortMap=6
DiskIdxMap=00

below images are from proxmox  when baremetal install failed.

System HW:

Edited September 28, 2022 by bas1212

[bas1212]

Just came to the conclusion that in the bare metal install the ethernet driver from the motherboard is to new.
Intel 2.5gig adapter, just ordered an new realtec network card

 

[rojoone2]

I have not built anything on an Intel 10th gen MB, but I do have a barematal build on an Intel 9th gen with a Realtek 2.5gb NIC.

Have you tried adding the Intel gigabit driver before your build command? ./rploader.sh ext apollolake-7.1.0-42661 add https://raw.githubusercontent.com/pocopico/rp-ext/master/igb/rpext-index.json

 

But first, post the output of your build so others can check for errors.