bas1212

Just came to the conclusion that in the bare metal install the ethernet driver from the motherboard is to new. Intel 2.5gig adapter, just ordered an new realtec network card

Hi all, I wanted to install dsm on proxmox but I got confused and tried to switch to baremetal. I need some advice. I tried to install xpenology with redpill tcrp loader on baremetal , but after creating the bootloader , the synology was not found. rploader satamap says no warning and shows 6 ports and 4 drives. I also have 4 drives plugged in and 1 nvme drive. So I tried to install on proxmox but now I get errors when installing, I have enabled hotplug for the sata ports.but where im a bit confused is that I have an nvme disk that I cannot disable. I have installed proxmox on that and I can see the 4 other disks. But If I called correctly I cannot install DSM on an nvme drive? If I want to install DSM on baremetal should I remove the nvme drive? and try the red pill loader again? This is my config for baremetal. tc@box:~$ ./rploader.sh identifyusb Found SanDisk Ultra SerialNumber: 4C531001330818121533 Vendor ID : 0x0781 Product ID : 0x5591 Should i update the user_config.json with these values ? [Yy/Nn] Y tc@box:~$ ./rploader.sh serialgen DS918+ Serial Number for Model = 1780PDN016484 Mac Address for Model DS918+ = 00:11:32:7F:F8:7A Should i update the user_config.json with these values ? [Yy/Nn] Y tc@box:~$ vi user_config.json tc@box:~$ ./rploader.sh satamap Found "00:17.0 Intel Corporation Device 43d2 (rev 11)" Detected 6 ports/4 drives. Override # of ports or ENTER to accept <6> Computed settings: SataPortMap=6 DiskIdxMap=00 below images are from proxmox when baremetal install failed. System HW: