chiefg

I using a m-shell and have DVA3221 working with a Quadro P2000, transcoding is working fine, currently on update 1, can I update to update 4 manually?

Does the DVA3221 build takes advantage of the NVIDIA GPU (if installed) when using PLEX? NVM it seems it does work, thanks!

That did the trick thanks

I edited cmdline SataPortMap 6488 the DiskIdxMap 050800 (you can play around with the diskidxmap to align the disk perfectly but i dont care about it, all disks are recognized)

EPC621D8A mobo with Intel X540-T2 , unable to load latest ARPL with 10GB nic, gives error getting IP after building and booting embedded NICs worked, recognized all 18 drives Would like to get 10GB NICs working , any suggestions? FYI with Alpha build the NIC X540-T2 gets recognized no issues other than it keeps crashing the volume after reboots, bare metal setup

I have the same issue with an Intel X540-T2 10gb nic, it used to work until beta came out. Now if it's installed neither beta works, when I remove it and use the onboard 1gb card the beta loads and works ok with the 10gb after it boots it shows "ERROR" in red next to IP

Hi all, I have the following setup, motherboard has two onboard controllers regular sata 6 SAS 3 4 Then I have two SAS3 controller, each has 8 ports so 8,8 here is what my SataPortMap will be ----- 6488 here is what my DiskIdxMap will be ----- 050800 All ports will have a drive, is this correct? Thanks