Jump to content
XPEnology Community

cospotato

Transition Member
 View Profile  See their activity

  • Posts

    18

  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

cospotato's Achievements

Newbie

Newbie (1/7)

1

Reputation

  1. cospotato
    Hi pocopico! I'm using DS3615xs 7.0.1-bromolow-42218. Hardware is : Microserver Gen8 with Xeon E3-1265L. The 10G NIC is Intel 82599.
  2. cospotato started following pocopico
  3. cospotato
    Hi @pocopico. Please look around this problem. My Server is Microserver Gen8. If i install Intel 82599 NIC. The server fall into restart loop. Thanks !
  4. cospotato
    Hello @pocopico! My server is ok to boot without Intel 82599 NIC. If i install the NIC. Server fall into restart loop. How to debug? Thanks!
  5. cospotato
    Update: I successfully access the DSM! The problem i was met is the 10G NIC IP has filled in the on-board 1G NIC. I captured package on that port found this. Now the problem is: If i install the 10G NIC card. Although rebuild loader in tinycore. But the system fall into restart loop. Note: My 10G NIC cart is Intel 82599
  6. cospotato
    New problem. After I migrate and finish install DSM. Cannot reach the network again (without 10G NIC installed). Note: I create LACP port bond before in 6.2.3 Then i force poweroff the server. The server fall into restart loop. I rebuild the loader, remove the 10G NIC, boot. This time i wait the Disk led stop flash, force power off again. Install the 10G NIC. (Because i configured static ip on the 10G NIC card) After boot, the 10G NIC port led flashing. But i cannot reach the server with static ip configured before either. I force power off again. This time i boot into tinycore. Rebuild loader with 10G NIC again, reboot. Now the 10G NIC not flash.
  7. cospotato
    I found the problem. I have a dual-port 10G NIC installed.I try to remove it before booting. Then the server fetched the IP.
  8. cospotato
    Hello @pocopico@Aigor, My server is microserver Gen8. I followed this https://xpenology.club/install-dsm-7-on-baremetal-or-vm/ tutorial tried again and again. But after reboot. The Server stuck at this screen. And never fetch IP from my DHCP Server. Please help! I also fetched the console output with iLO VSP console.log
  9. cospotato
    But i wait for half an hours. Nothing happened😂
  10. cospotato
    Hello @pocopico@Aigor, The full serial log attached here. Thanks ! serial.log
  11. cospotato
    Sorry! My fault! It's 2x8Gb😂
  12. cospotato
    In iLO, use command "VSP". It auto selected COM2.
  13. cospotato
    The Serial output stop at this line.
  14. cospotato
    Hello, I get this error in the serial output: [ 2.299674] redpill: module verification failed: signature and/or required key missing - tainting kernel
  15. cospotato
    OK. Thanks. I'll try it first.
  16. cospotato
    Server: HP Microserver Gen8 CPU: E3-1265L Mem: 16G DDR3 1600 x 2 Disk: not installed
×
×
  • Create New...