down_shift Posted October 16, 2017 Share #1 Posted October 16, 2017 Nanoboot (5.0.3.2) DSM 5.0-4528 been running solid for over two years. Last week we had a power outage and it never came back online. Connected monitor and keyboard to troubleshoot. Box ox will boot into the loader. Once it goes through selecting dsm5 it will show “booting nanoboot (5.0.3.2) DSM 5.0-4528” root (hd0,0) filesystem type is fat. Partition type 0xb kernal /zimage ihd_num=8 netif_num=4 syno_hw_version=DS3612xs etc etc (Linux-bzimage, setup=0x3c00, size=0xc54220) Then it will be a completely blank screen. I’ve never had this issue before with previous reboots. I checked my bios settings. They are all still the same profile. Open to suggestions is there a troubleshoot guide? thanks Quote Link to comment Share on other sites More sharing options...
sbv3000 Posted October 16, 2017 Share #2 Posted October 16, 2017 That us an old loader so there is limited support I would test as follows; Disconnect your raid drives Use a live Ubuntu boot disk to check your hardware, network etc If thats ok Test your boot usb drive on another PC to see if it boots/appears on the network as Reflash the usb boot drive with the same boot image Boot the NAS with the reflashed boot image and see if it appears on the lan, if yes then power off and reconnect drives etc You should consider upgrading/migrating to XPE5.2/DSM 5.2 and then to 6.x (if your hardware supports it) Quote Link to comment Share on other sites More sharing options...
down_shift Posted October 19, 2017 Author Share #3 Posted October 19, 2017 I just tried the boot image on my laptop. It is doing the same thing except it goes into a reboot loop. Will i lose my hard drive data if I load a fresh copy of the usb ? It should just rebuild my array? i will update to latest once this is resolved. I just never wanted to upgrade due to the system being stable for such a long time. Quote Link to comment Share on other sites More sharing options...
down_shift Posted October 19, 2017 Author Share #4 Posted October 19, 2017 I have flashed a new boot usb drive. Not sure if it’s the exact same image but it’s the closest I can get. Now. If I were to reconnect my array. Will it format all my data or pick up that it was an array previously and offer to rebuild ? Quote Link to comment Share on other sites More sharing options...
sbv3000 Posted October 20, 2017 Share #5 Posted October 20, 2017 Ok so it looks like your hardware is ok. If you look at the Loader archive, you should be able to find the exact one that matched your install, flash with that and retest If its all ok with that loader, then you can reconnect your drives and it should work. If you continue with the loader you have, then make sure you have the correct version of DSM to match it, you will be prompted to 'migrate', if its a higher version. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.