Simone95 Posted January 4 Share #1 Posted January 4 Good morning everyone. I'm trying to install DSM 7.x on my HP Z820 workstation. I used Automated Redpill Loader to load the loader onto the USB stick. During configuration I chose the DS3615xs model and build 42962. The loader starts correctly but does not detect the two SATA disks present (Seagate Ironwolf). I configured SATA mode in AHCI from the BIOS and then in IDE but in neither configuration the disks are detected. Am I doing something wrong? Can I change model and/or build? Thank you all Quote Link to comment Share on other sites More sharing options...
ANDREW 8077 Posted February 15 Share #2 Posted February 15 Did you get this working? I have been trying with 920+ and a few others but after getting to "no disk" DSM screen once, I've not been able to get the loader to even boot again. It gets to the screen you show above and then the cursor stops blinking. Quote Link to comment Share on other sites More sharing options...
rojoone2 Posted February 15 Share #3 Posted February 15 (edited) I have a Z440 and had to disable the two standard SATA ports, using only the four sSATA ports in order for the disks to be recognised. Try only using either the six SAS ports, or the four SATA (SCU) ports. Instead if trying to build the DS3615xs, which is out of support, use the DS3622xs+ instead. It is compatible with a wider selection of hardware. Edited February 15 by rojoone2 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.