passat_mg

Thanks for all your answers. It looks like my home project will have to change --> 10gbps NICS / switch (bit expensive).

Hello and welcome to the forum, I use a Cisco SG200-08 with the hardware in my signature. Thanks for your reply. Do you actually get transfers above 113 MB/s? Is there anyone else who can confirm higher transfers in 1 gigabit network using link aggregation?

Hi All, This is my first post, so in the beginning I would like to thank you all for everything what you do on this forum. Myself, I do not have good experience with link aggregation. I cannot get better transfer than 113 MB/s which only 1 gigabit speed. I have managed to bond NIC with 4 gigabit ethernet ports (4000 Mbps, Full duplex, MTU 1500 – either static or dinamic) on Asus P8H61-MX with Intel Pentium G620 DDR3 8GB Raid 5 WD Red 3TB LSI 9211-8i IT mode, Intel PRO/1000 PT Quad - DSM 6.0.2-8451 Update 9, Jun's v1.01 loader. Xpenology is connected to TP-Link switch T2600G-28TS. On the other end, I have Asrock z97 Extreme 6, CPU 4790K, DDR3 16GB, Samsung 950 Pro 512GB, Intel I350-T4 – tested on Windows 7 and Windows 10 I have tested on different hardware as well TP-Link TL-SG3210, i3-2120 Lenovo CiH61M, different NIC cards NC360T, NC364T - DSM 6.0.2-8451 Update 9, Jun's v1.01 loader or DSM 5.2-5644 DS3615xs Polanskiman – what kind of hardware do you have - switch, NIC’s? Did you manage to get higher transfers then 1 NIC card? This is my home project but slowly I am running out of the options. Re Twisted I think your switch should be able to bond your NIC card. Please see http://uk.tp-link.com/products/details/cat-41_TL-SG108E.html#specifications Also Please check your switch manual Chapter 4 LAG config http://static.tp-link.com/Easy%20Smart%20Configuration%20Utility_User%20Guide.pdf