iancilos

4. Add EMMC as the system installation disk (synoinfo). As soon as I read this point I immediately wanted to try it. I have a mini PC with 64GB EMMC and I would like to use it like this. I built the loader using ds918+ from USB and the new option in synoinfo: support_emmc_boot=yes - Only use EMMC as the system disk(applicable without Sata) When the loader starts, no disk is detected when installing DSM. I would love to have more explanation from @wjz304 about this point to make it work, that would be great! If wjz304 needed a tester for this hardware I have 2 different mini pcs with emmc. AcePC T11 Asus PN40

@wjz304 please could you give me some values to try? I tried and the disk is always seen as internal n17 or it is not detected as internal. I would like to try to show it as n1, maybe it solves the dmesg problem that I attached before. Thanks for your help

Hi jz304! It's thanks to your guide that I managed to get to this command: How do you think I should change it? I didn't understand if I should combine it with: Usbportcfg=0x000000000 to make it work correctly

Hello everyone! I installed DSM 7.2.1-69057 via the arpl-i18n-23.9.7 loader on an ACEPC T11 MiniPC and it works incredibly well in terms of power and consumption! However, I have the problem when turning off or restarting DSM... Attached is the DMESG that I collected, I believe that you deactivate the sata USB disk earlier than necessary. During configuration, the loader does not see the internal disk as PCI/SATA but as USB/SATA and by setting the following values: The disk is seen as internal to position no. 17. DSM installs correctly, everything works as it should. The problem is only when shutting down or restarting. Could I solve this by showing port 17 as port 1? How should i do? Greetings everyone! dmesg.txt