[RedPill - the new loader for 6.2.4 - Discussion]

54 минуты назад, pocopico сказал:

 

Make sure that the network card is set to e1000e. Thats the only VMware adapter that will work out of the box.

 

 

I found my error.

I put mac address in configuration with ":" symbols. Removing symbols fixed the problem.

Thank you for support!

Now it is working!!!

[RedPill - the new loader for 6.2.4 - Discussion]

3 минуты назад, imdgg сказал:

after installed dsm,you should mount /dev/synoboot1 ,and edit grub.cfg file

add the parameters ‘DiskIdxMap=0c00 SataPortMap=1’ to the grub.cfg file

Actually dsm boot process was finished, but without network. Should I do what you said?

Please see the log, may be i can not see something important?

logboot.txt

[RedPill - the new loader for 6.2.4 - Discussion]

5 часов назад, imdgg сказал:

 

when you see the boot menu,

choose SATA boot and press e to edit boot menu

add ‘DiskIdxMap=0c00 SataPortMap=1’ at the end of the boot args entry.

then press ctrl+x to boot

 

 

Аfter I did this - the disk was appeared and installation process was successfully finished. But after reboot the vm(boot was with the same parameters) I can not ping the vm, it does not start.

Removing parameters ‘DiskIdxMap=0c00 SataPortMap=1’ boot the vm in dsm installation again without disks.

 

 

[RedPill - the new loader for 6.2.4 - Discussion]

Hi guys!

I have microserver gen10+(xeon 2246) with esxi7.0u2 installed. Boot image made with redpill-tool-chain_x86_64_v0.10 and converted it to vmdk.

The system I was trying to assemble redpill-DS918+_7.0.1-42214_b1632684538.img

The instructions I used.

Firs time I boot I checked the SATA boot, the system Is trying to boot, it even accessible by the web, but it can not see the disks.

If I move data disk to Sata Controller0(0:1), then setup sees 2 disks and trying to zero them - of course it fail after some time.

 

Please help to make disks visible on Sata Controller 1 or 2.