m8kbv
-
Posts
5 -
Joined
-
Last visited
Posts posted by m8kbv
-
-
5 minutes ago, IG-88 said:
the driver mentioned is only usable with dsm 6.2
dsm 7.0 has a different kernel version and that will prevent the driver to work
if you use tinycore rp loader and let it detect you hardware then the card should work
the driver is present in pocopicos extension repository
I just did tinycore on ds918+ from scratch last night (I forced a system update and it crashed, hung on recovery mode), and to my surprise the card works, I have 10Gbe on DMS 7.1:-)
-
Hi. curious about the article
https://servicemax.com.au/tips/synology-10gigabit-ethernet-on-the-cheap/
I purchased an Asus 10GBe rj45 card. I am encountering an error when executing instructions in ssh:/usr/local/etc/rc.d/aqc107.sh start installing config removing synology kernel driver rmmod: ERROR: Module atlantic is not currently loaded installing proper module from /volume1/aqcnetconf/atlantic.ko insmod: ERROR: could not insert module /volume1/aqcnetconf/atlantic.ko: Invalid module format restarting networking, dont panic /etc/rc.network: line 1194: nat_stop_dhcpd: command not found [dhclient@eth0.service] stopped. [dhclient6@eth0-client.service] stopped. [dhclient6@eth0-info.service] stopped. [dhclient6@eth0-pd.service] stopped. [dhclient@eth1.service] stopped. [dhclient6@eth1-client.service] stopped. [dhclient6@eth1-info.service] stopped. [dhclient6@eth1-pd.service] stopped. [dhclient@eth2.service] stopped. [dhclient6@eth2-client.service] stopped. [dhclient6@eth2-info.service] stopped. [dhclient6@eth2-pd.service] stopped. [dhclient@lo.service] stopped. [dhclient6@lo-client.service] stopped. [dhclient6@lo-info.service] stopped. [dhclient6@lo-pd.service] stopped. [dhclient@tun.service] stopped. [dhclient6@tun-client.service] stopped. [dhclient6@tun-info.service] stopped. [dhclient6@tun-pd.service] stopped. eth1: ERROR while getting interface flags: No such device eth2: ERROR while getting interface flags: No such device tun: ERROR while getting interface flags: No such device 0 0 0 0 unknown
Finally, it only loads my built-in network card.
Is Xpenology in DSM7 not possible to install this card? -
Hello. Is there any progress on the launch of NVME on Xpenology?
-
On 7/10/2018 at 1:22 AM, modboxx said:
How to run NVME on DSM 6.2? I installed the PM961 256GB NVME in the m.2 slot on the motherboard (I also tried through the resizer) and is not visible in my xpenology.
Synoboot without extra.lzma for DS918 +.
Computer Hp 600 G3 Sff.
Asus XG-C100C AQC107 od DSM 7.1 DS918+
in General Post-Installation Questions/Discussions (non-hardware specific)
Posted
This is how it works so far, I did from scratch configurations through redpill, the system detected it automatically during configuration.
The heatsink is hot even when the card does nothing, I wonder how this temperature will affect the card's operation in the future.