m8kbv

This is how it works so far, I did from scratch configurations through redpill, the system detected it automatically during configuration. The heatsink is hot even when the card does nothing, I wonder how this temperature will affect the card's operation in the future.

I just did tinycore on ds918+ from scratch last night (I forced a system update and it crashed, hung on recovery mode), and to my surprise the card works, I have 10Gbe on DMS 7.1:-)

Hi. curious about the article https://servicemax.com.au/tips/synology-10gigabit-ethernet-on-the-cheap/ I purchased an Asus 10GBe rj45 card. I am encountering an error when executing instructions in ssh: /usr/local/etc/rc.d/aqc107.sh start installing config removing synology kernel driver rmmod: ERROR: Module atlantic is not currently loaded installing proper module from /volume1/aqcnetconf/atlantic.ko insmod: ERROR: could not insert module /volume1/aqcnetconf/atlantic.ko: Invalid module format restarting networking, dont panic /etc/rc.network: line 1194: nat_stop_dhcpd: command not found [dhclient@eth0.service] stopped. [dhclient6@eth0-client.service] stopped. [dhclient6@eth0-info.service] stopped. [dhclient6@eth0-pd.service] stopped. [dhclient@eth1.service] stopped. [dhclient6@eth1-client.service] stopped. [dhclient6@eth1-info.service] stopped. [dhclient6@eth1-pd.service] stopped. [dhclient@eth2.service] stopped. [dhclient6@eth2-client.service] stopped. [dhclient6@eth2-info.service] stopped. [dhclient6@eth2-pd.service] stopped. [dhclient@lo.service] stopped. [dhclient6@lo-client.service] stopped. [dhclient6@lo-info.service] stopped. [dhclient6@lo-pd.service] stopped. [dhclient@tun.service] stopped. [dhclient6@tun-client.service] stopped. [dhclient6@tun-info.service] stopped. [dhclient6@tun-pd.service] stopped. eth1: ERROR while getting interface flags: No such device eth2: ERROR while getting interface flags: No such device tun: ERROR while getting interface flags: No such device 0 0 0 0 unknown Finally, it only loads my built-in network card. Is Xpenology in DSM7 not possible to install this card?

Hello. Is there any progress on the launch of NVME on Xpenology?

How to run NVME on DSM 6.2? I installed the PM961 256GB NVME in the m.2 slot on the motherboard (I also tried through the resizer) and is not visible in my xpenology. Synoboot without extra.lzma for DS918 +. Computer Hp 600 G3 Sff.