hehe8899
-
Posts
6 -
Joined
-
Last visited
Posts posted by hehe8899
-
-
14 hours ago, hehe8899 said:
Also no network control pannel in DSM. And the peer openwrt router reboot again and again...
BUT the interface 2.5g of peer openwrt router works well with same realtek USB-2.5g of PC as following. I am confusing...ANY suggestion?
-
17 hours ago, IG-88 said:
driver looks ok, you can check dmesg for log messages about link speed
did you reboot? usb nic's will only show up in the gui after a reboot (or maybe after restarting the network services manually)
reboot & dmesg as following. And the peer openwrt router show link entered into forwarding state.
-
-
I've recently annouce that my work on a kernel mode dynamic patcher in this post
....
How to install:
find the vid/pid of your usb drive
Burn the image to the drive, optionally edit grub.cfg to set vid/pid and boot entry, OR
connect monitor/keyboard/serial console to your Box.
Press C during Grub boot menu to enter command line
vid 0xXXXX pid 0xYYYY
to configure pid and vid ("pid" and "vid" are command, and "XXXX", "YYYY" are you usb drive's vid,pid)
(There are a few other options can be config this way, you can read grub.cfg to know more detail.)
Press Esc to go back to boot menu
Select baremeta/baremetal AMD entry, press enter to boot.
If your encounter the "disk port disabled" error during installation, try the force install menu entry.
if both option does not work, you have to fallback to SataPortMap method,
type this line in grub command line, replace XX with appropriate value.
append SataPortMap=XX
11/2:
as I promised, here is v1.01, download link is the same as v1.0
This update contains nothing fancy, mainly for inner peace,
Plus, I revert megaraid_sas mpt3sas to old version.
It's not shining new now, the title is obsolete
My HP Microserver Gen8 can't boot by U-disk burned in your loader v1.01 as your indicate above. It shows "Non system disk" but works well with 5.2 XPEnoboot_DS3615xs_5.2-5644.5 from this forum.
As I known, Gen8 can't boot by UEFI mode. Any suggestions?
update: The U-disk above was unstable and my Gen8 was updated to DSM 6.0.2 with new U-sidk by your loader v1.01. Thanks!
-
Great!
But WOL can't work on my DSM 5.0-4482 with this boot(5.0.2.4). My borad is B75M-ITX and LAN chip on board is Realtek RTL8111E. WOL work well with gnoBoot on 4458 update2.
Please help me with thanks!
Driver extension jun 1.03b/1.04b for DSM6.2.3 for 918+ / 3615xs / 3617xs
in Additional Compiled Modules
Posted
Should i insert usb-2.5g mac address into grug.cfg? @IG-88