Just installed xpenology with dsm 6.1 (ds3615) with juns loader 1.02b on the PX6-300d (6 drive NAS). Pretty straight forward using this guide to boot from usb.
After that it booted right up and installed DSM with the synology assistant. Working good so far with no issues and all 6 bays can be utilized.
Thank you very much netrider, I could install XPEnology on a Iomega NAS px4-300d (very similar to yours, but with just 4 disk drives). I am very glad with the change...
What I am looking for now, is the VGA bracket for these mainboards.
Does anyone know the name (and where to buy) this kind of connector (I attach pictures)? It is a 16-pin header to connect a VGA bracket, used by Iomega on some NAS boards (for example, on StorCenter px4-300d and px6-300d). The pins are very short (not the typical ones on old PC motherboards), and are closer to each other (in two rows of 8 pins each).
The bracket needed is SIMILAR to the one that appears on this page: https://www.shuttle.eu/en/products/accessories/pvg01
However, the bracket shown there has 20 pins (two rows of 10 pins each), but the one needed on the Iomega NAS mainboards should have 16 pins.
Knowing the pinout would be an extra nice and useful achievement!
In case the pictures cannot be attached, they are online on:
XPEnology on Lenovo storcenter PX6-300d
in Hardware Modding
Posted
Thank you very much netrider, I could install XPEnology on a Iomega NAS px4-300d (very similar to yours, but with just 4 disk drives). I am very glad with the change...
What I am looking for now, is the VGA bracket for these mainboards.
Does anyone know the name (and where to buy) this kind of connector (I attach pictures)? It is a 16-pin header to connect a VGA bracket, used by Iomega on some NAS boards (for example, on StorCenter px4-300d and px6-300d). The pins are very short (not the typical ones on old PC motherboards), and are closer to each other (in two rows of 8 pins each).
The bracket needed is SIMILAR to the one that appears on this page: https://www.shuttle.eu/en/products/accessories/pvg01
However, the bracket shown there has 20 pins (two rows of 10 pins each), but the one needed on the Iomega NAS mainboards should have 16 pins.
Knowing the pinout would be an extra nice and useful achievement!
In case the pictures cannot be attached, they are online on:
https://deviwiki.com/w/images/6/65/Px6-300d_front.jpg
https://www.reddit.com/r/homelab/comments/11ho7v8/lenovo_emc2_px6300d_help/
Thank you very much in advance, dear community!
Regards,
GABRIEL