[High availibility with 2 hypervisor vm’s]

Thanks,

 

as test im doing a setup on a dl380p gen8.  It has a e5-2620 v1 cpu. I get slightly further. Vm’s have 2 nics mtu is set 9000 second noc in a seperate vlan. The HA setup gets created but once it is there they sync but the passive mode is stated sisconnected. Also i get dsm model and ip but not version of dsm etc in the cluster details. Also i’m wondering if vmnet3 is correct or should i use intel 1000 or 1000e. To get it properly set. After rebooting cluster cannot get it to properly work.

[High availibility with 2 hypervisor vm’s]

Hi,

 

i have xpenology running on 2 different vm’s.

 

first one of proxmox second one on esx. I’m trying to create a HA setup but fails. Both have same dsm version en both have 2 nics which are visible in the initial setup. Don’t have dhcp server or ipv6 on the nic’s. When intry to create the initial setup i see the nics en select primary and the standby nic and press next. But it fails. Inhave blocked the second nics to mu dhcp so they get a 169.xxx address but no succes. 
 

does anyone know what im missing or if this is even possible due to the setup. The machines have 1 physical nic but 2 virtual nics. Mac address etc are all ok.

 

but the physical connection are on a switch. I tried to add vlan but it also fails.

 

hemant

[DSM 6.2 Loader (with MBR partition Table)]

Hi,

 

trying to use it on a dell wyse amd machine with 8111.

 

tried normal version 3615, 3617, 918 loaders en system is not found with 1.03b or 1.04.

 

To test i switched to 1.2b uefi system is found bit hangs in migratble status each time i finished. Tested after several attempt with 1.0b mbr genesys and finally i could complete the setup.

 

with triggered me to go for 1.3b mbr but now i get this error so confused

 

hemant