[Only HDD in Bay 1 are found by Storage Manager]

As suggested I built a new DS920+ 7.0.1-42218-JUN mode build ( ./my.sh DS920+J jumkey ), then upgraded to  7.1 via ./rploader.sh build  geminilake-7.1.0-42661. The reboot finally had all 4 disks present and HW Transcoding works. No editing needed...

 

 

[Only HDD in Bay 1 are found by Storage Manager]

On 6/4/2022 at 9:57 AM, flyride said:

/home/tc is a reference copy.  If you edit that copy, it will have no impact on your system.

Flyride,

 

HI. I was following this thread as I was experiencing a similar issue with my ASROCK J4125 - The 2 (ASMedia) Sata ports are not being mapped correctly using DS920+. (Works fine with DS918+, but on that build the Hardware Transcoding is failing under Jellyfin even though I have the Dev/Dri and 915.ko files installed...)

Anyway - you stated :

You can fix this by booting into TinyCore, then:

./rploader.sh restoresession geminilake-7.x.x-xxxxx

# edit the ds920+.dts file to reflect the port suggestions above
vi /home/tc/redpill-load/custom/extensions/redpill-dtb/ds920p_xxxxx/model_ds920p.dtb

./rploader.sh clean
./rploader.sh build geminilake-7.x.x-xxxx

Unfortunately - when I followed this, the requestedfile is not in this directory - (Only recipes and release directories without any .dtb files) so I'm not sure what happened there. Do I need to do a full rebuild somehow to get this? 

I've enclosed a .txt file with the system info I typically see requested: lspci -tvnnq , cat /proc/cmdline , ls -la /sys/class/ata_port , dtc -I dtb -O dts /var/run/model.dtb

920device info.txt