Jump to content
XPEnology Community

Installed Jun's 1.02b on DX4000 only 100Mbps not 1Gbps

Recommended Posts

Not the cable as other devices detect it as 1Gbps no problem. When I first got it installed and booted it specifically said the card was 10/100 and to consider upgrading so I don't think it is being detected correctly. Not really sure where to go about troubleshooting to get the correct module loaded. Tried the extra.lzma but it doesn't boot on here. Using DS916+ if that matters.

Link to comment
Share on other sites

This topic is now closed to further replies.

  • Create New...