Good afternoon,
I would like to know if someone could help me with a problem that has come up. Until today, I had an xpenology with two hard drives running without any problem. Today I have decided to install two additional hard drives so I have set to it. I have only connected two hard drives with their connections and I have connected it again. The bios of the board detects the four disks but xpenology does not start. When I connect the nas to a monitor I see that the message appears on the board, and then, instead of a text message that always remains so relative to xpenology, an intermittent cursor appears. Some help? I forgot to say that, if I remove the two new discs, it does not start either, it remains, once the initial screen of the motherboard is passed, with the cursor flashing.
Question
SHINZONITO
Good afternoon,
I would like to know if someone could help me with a problem that has come up. Until today, I had an xpenology with two hard drives running without any problem. Today I have decided to install two additional hard drives so I have set to it. I have only connected two hard drives with their connections and I have connected it again. The bios of the board detects the four disks but xpenology does not start. When I connect the nas to a monitor I see that the message appears on the board, and then, instead of a text message that always remains so relative to xpenology, an intermittent cursor appears. Some help? I forgot to say that, if I remove the two new discs, it does not start either, it remains, once the initial screen of the motherboard is passed, with the cursor flashing.
Thank you.
Edited by SHINZONITO2 answers to this question
Recommended Posts