Arduino

Jun's loader trouble unsupported NIC

Recommended Posts

Hello everyone I am very new to the Xpenology scene and i have only ran 5.2 with Xpenboot. I am trying to use the latest DSM 6.1.2 but have had no luck. The Synology Web Assistant and my router can not see my box. I have a Dell Optiplex 380 and I am using the on-board network port. If any specifics are needed I will look at the board and manual. Any help is greatly appreciated.

Share this post


Link to post
Share on other sites
32 minutes ago, Arduino said:

Hello everyone I am very new to the Xpenology scene and i have only ran 5.2 with Xpenboot. I am trying to use the latest DSM 6.1.2 but have had no luck. The Synology Web Assistant and my router can not see my box. I have a Dell Optiplex 380 and I am using the on-board network port. If any specifics are needed I will look at the board and manual. Any help is greatly appreciated.

I believe the it is a Broadcom NX1 5722 10/100/1000 PCIe Gigabit Networking Card

Share this post


Link to post
Share on other sites

Arduino,

 

I could not get Broadcom NiC's to work with 6.1.  Here is some discussion's on NIC's that should work.

 

Share this post


Link to post
Share on other sites

Thank you very much Terabyte I was looking for a different NIC. I appreciate the help.

Edited by Arduino
Typo

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now