Jump to content
XPEnology Community
  • 0

JMB585 does not see the hdd during installation


JNAS
 Share

Question

Installed the sata controller https://aliexpress.ru/item/1005004255682694.html

Hooked up 5 hdd to it. I have a total of 9 hdds. 4 on the motherboard and 5 on JMB585. Re-created the TCRP. Plugged in all 9 hdds and started installing the DS920+
Installing DS920+ 7.1.0-42661. Doesn't see the disks that are on JMB585. Where should I go?

Edited by JNAS
Link to comment
Share on other sites

3 answers to this question

Recommended Posts

  • 0
7 минут назад, rojoone2 сказал:

Did you configure your device tree?

With 9 drives, you may be better off building a DS3622xs+ instead of a DS920+. Unless you are using hardware transcoding?

 

That's why I switched to the 920+ because I couldn't set up the device tree on the 918+, but I'm about to try the DS3622xs+ and see what happens.

Link to comment
Share on other sites

  • 0

Which loader are you using ? On TCRP 0.9 an automatic patching of the DTB is included. You could also try ARPL.

 

Edit: Also, do you see the disks if you login to http://yourip:7861 with user root and no pass when you execute :

 

fdisk -l

 

Edited by pocopico
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

×
×
  • Create New...