TCRP Stuck in recover loop DS3615xs

[Spats]

Guys managed to get the above installed but when it goes to reboot and starts the countdown it gets stuck in recover mode after counting down.

 

the setup is Dell R710 server.

2 x Intel Xeon L5630@2.13Ghz
24Gb DDR3 ECC memory
Dell Perc 200I flashed to IT mode
iDRAC6
4 QLOGIC BCM5709C onboard

INTEL PRO 1000 dual 1gbe nic card that i am using

 

 ./rploader.sh update
./rploader.sh fullupgrade
./rploader.sh identifyusb

./rploader.sh serialgen  realmac

./rploader.sh listmods bromolow-7.0.1-42218

./rploader.sh build bromolow-7.0.1-42218

 

I install the DSM_DS3615xs_42218 pat file from but when it reboots to start it just counts down then it says recover.  

 

I am stuck with this one guys

 

cheers

Spats_RedPill DS3615xs.txt

Edited June 24, 2022 by Spats

[IG-88]

try 3622 as its the better choice, 3615 should be kind of a last resort if anything (extremely old) does not work with kernel 4.4 and needs kernel 3.10

you can also try to disconnect the system from internet after configuring the loader and install the dsm *.pat file from local network

(you might need to empty the disk in the system too, just remove all partitions from the disks, assuming its a fresh install)

[Spats]

Did get it eventually @IG-88 by going the 7.1 route instead of 7.0 what i was trying.

 

thanks again