Jump to content
XPEnology Community

Recommended Posts

Posted

Originally, my quickconnect was still work on last week!

I have perform fresh re-install my NAS but I have problem to setup the quickconnect. It is Synology Problem or any?

 

Thanks!

Posted
Originally, my quickconnect was still work on last week!

I have perform fresh re-install my NAS but I have problem to setup the quickconnect. It is Synology Problem or any?

 

Thanks!

 

Yeap works fine!

Posted

Any step recommend?

 

I didn't enable the firewall.

I have successful register the DDNS from no-ip.com.

I use the same serial number that original register!

I didn't change the MAC address! (It was use before to make the Quick Connect work)

 

Any suggestion?

 

Thanks!

Posted

Use dyndns or some other service do not leach off of synology features like that. That is for the people who bought synology hardware.

 

I use dyndns and it works well.

Posted

I have perform the fresh install by using the same Hardware with same Serial Number and MAC Address.

I have enable DHCP from my TP-Link TL-WDR3600 router with LAN Cable connected. I have reserve the IP to this NAS.

I have put the NAS's IP into DMZ.

I have register the Dynamic DNS by no-ip.com. The registered domain is XXXX-XXXXX.no-ip.org with successful added into the "External Access" with successful login with status as "Normal".

 

Do I need to enable something to perform the QuickConnect setup? For Example, enable guess, install some package....etc

 

Thanks!

Posted

Quick connect is not needed with your setup. Once fully setup and ports forwarded from your router, you should just be able to go to the address you set up.

Posted

Good, let me try!

 

May I know you can register quickconnect on 5.2-5967 or originally work then upgrade to 5.2-5967?

 

It is because I use 5.2-5644.5 before with working fine. Then I try to clean install 5.2-5644.5 again but cannot register again!

×
×
  • Create New...