Jump to content
XPEnology Community

Strange issue with eth0 not running.


ctltd
 Share

Recommended Posts

I am trying to repurpose a Gigabyte motherboard to run xpenology. it is a F2A85X-4UP with an AMD A6 processor. I tried the latest USB boot drive and it booted fine but said eht) not running. It has a realtek PCIe GBE network adapter so I saw where there wasn't a driver for it. So looking at the 'working hardware' list I found that TP-Link TG4368 adapter was working. I bought one and installed it and xpenoboot boots fine but this new network adapter doesn't work either. I get the same message 'eth0 not working'. and it is not visible or available on the network nor in the DHCP list from the router. Not sure where to go from here. Any suggestions???

 

Steve

Link to comment
Share on other sites

 Share

×
×
  • Create New...