Jump to content
XPEnology Community

Recommended Posts

Posted

On my current XPEnology build running on my server;

 

Xeon E3-1220v2

8GB DDR3 ECC / U

12x 500GB SATA III 7,200RPM

LSI MR 9266-4i

*Disks are passed through as individual RAID0 arrays as the card doesn't support JBOD.

 

It sees disk 7,8,9,10,11,12 but doesn't see anything other than that. Any help would be appreciated.

Posted

Does your motherboard have six sata slots? If so, its likely assigned bays 1-6 for sata and hten the LSI card is kicking on from 7 onwards and after 12 you have to configure the system to show the additional bays. Best bet is to go in to the bios and disable the onboard sata if its still enabled and then report back.

Posted

It does have 6 ports, but the problem is, in the BIOS I only have options to switch it to IDE, RAID or AHCI. There's pretty much no way to disable them. Is there anyway I could get XPenology to stop looking at the board and look at the RAID Card instead?

Posted

You might be able to get XP to unload the sata drivers, but I can't help you there... Trantor could help you if you do a message to him.

 

What's the motherboard?

×
×
  • Create New...