syvlvr Posted February 1, 2016 #1 Posted February 1, 2016 So starting my journey, haven't found a way yet to get xpenology to work with esxi on my Gigabyte GA-9SISL motherboard. Have followed instructions, done a few ways. Basically, once the system reboots after the configurator appears to load the system, all I see in esxi is a blinking cursor. Wondering if it's an issue with the SATA onboard. May try a Dell raid card. Anyone have any thoughts? Thanks!
sbv3000 Posted February 1, 2016 #2 Posted February 1, 2016 Im guessing you have followed the various esxi setup tutorials and set the virtual disks correctly etc? This sounds like the VM does not have a properly configured boot disk https://idmedia.no/projects/xpenology/i ... -or-later/
Recommended Posts