Jump to content
XPEnology Community

How-To Verify Advanced LUN Allocation Unit Size


OzTechGeek
 Share

Recommended Posts

Does anyone know how to verify via SSH that the correct value for "Advanced LUN allocation unit size" has been set on a volume?

 

I have created 2 volumes on a test ESXi XPEnology install, both volumes are 64GB, I have set one volume to "4KB (Optimized for Windows ODX)" and the other to "8KB (Optimized for VMware VAAI)", but for some reason I cannot find a command line to verify that these settings have been applied, I have tried the following commands so far:

 

blockdev --getbsz /dev/sdX

blockdev --getss /dev/sdX

cat /sys/block/sdX/queue/physical_block_size

cat /sys/block/sdX/queue/logical_block_size

cat /sys/block/sdX/queue/minimum_io_size

cat /sys/block/sdX/queue/optimal_io_size

cat /sys/block/sdX/alignment_offset

 

I have tried the above commands on sda, sdb, md0, md1, md2 and md3. All commands provide the same numbers or am I missing something obvious.

 

Thanks

Link to comment
Share on other sites

 Share

×
×
  • Create New...