Jump to content
XPEnology Community

LSI MegaRaid 9260-4i for SSD Cache


andale

Recommended Posts

Hi @ all!

 

My new powertoy is up and running (see: viewtopic.php?f=2&t=6594#p39363)

 

Now I have a LSI MegaRaid 9260-4i including 2 Kingston 120GB SSDs left since I updated my workstation with the new 9361-8i.

 

The problem is that the 9260-4i's drives are not recognized as SSDs. I created two virtual drives each containing only 1 SSD.

 

Is there any possibility to get this working? Maybe some changes in the config?

 

Log from dmesg:

 

[    1.364975] scsi6 : LSI SAS based MegaRAID driver
[    1.392317] scsi 6:0:5:0: Direct-Access     KINGSTON SV300S37A120G            BBF0 PQ: 0 ANSI: 5
[    1.419325] scsi 6:0:6:0: Direct-Access     KINGSTON SV300S37A120G            BBF0 PQ: 0 ANSI: 5
[    1.424962] scsi 6:2:0:0: Direct-Access     LSI      MR9260-4i                2.13 PQ: 0 ANSI: 5
[    1.425290] sd 6:2:0:0: [sdg] 233373696 512-byte logical blocks: (119 GB/111 GiB)
[    1.425337] sd 6:2:0:0: [sdg] Write Protect is off
[    1.425339] sd 6:2:0:0: [sdg] Mode Sense: 1f 00 10 08
[    1.425371] sd 6:2:0:0: Attached scsi generic sg6 type 0
[    1.425375] sd 6:2:0:0: [sdg] Write cache: disabled, read cache: enabled, supports DPO and FUA
[    1.425565] scsi 6:2:1:0: Direct-Access     LSI      MR9260-4i                2.13 PQ: 0 ANSI: 5
[    1.425732]  sdg: unknown partition table
[    1.425802] sd 6:2:1:0: [sdh] 233373696 512-byte logical blocks: (119 GB/111 GiB)
[    1.425843] sd 6:2:1:0: [sdh] Write Protect is off
[    1.425845] sd 6:2:1:0: [sdh] Mode Sense: 1f 00 10 08
[    1.425873] sd 6:2:1:0: [sdh] Write cache: disabled, read cache: enabled, supports DPO and FUA
[    1.425912] sd 6:2:0:0: [sdg] Attached SCSI disk
[    1.426113] sd 6:2:1:0: Attached scsi generic sg7 type 0
[    1.426490]  sdh: unknown partition table

 

Cheers

Link to comment
Share on other sites

×
×
  • Create New...