Trying to run DSM 6.2.3-25426 on a Gigabyte GA-J3455-D3H as DS918+


Recommended Posts

Hi all,

and sorry, if this is not quite the right forum for the following - I just do not understand the forum categories no more... So, moderator(s), just feel free and move this at the right place.

Ok, what I want to do is what I wrote in the title, but even after I copied IG-88's latest extras and the rd.gz and zimage from DSM .pat to my USB boot stick, I still have >2 minutes start of DSM, changing from one (re)boot to the next by 20 to nearly 200 seconds after "upgrade" (from serial output) - and always ending with the message "tn40xx: Tehuti Network Driver..." although the GA-J3455N has double RTL8111.

All what I'd like to get is a so far calculatable reboot time of, say, 2 or 3 minutes,  and not 2 minutes one time and 5 minutes the next time.

Any hints available?

Best regards

Link to post
Share on other sites
2 hours ago, Jopa said:

"tn40xx: Tehuti Network Driver..."

that driver is just very talkative and tells about supported phy chips even when there is no hardware present, thats normal and not  a problem

 

2 hours ago, Jopa said:

All what I'd like to get is a so far calculatable reboot time of, say, 2 or 3 minutes,  and not 2 minutes one time and 5 minutes the next time.

some people use a smaller ssd as 1st drive so when dsm boots it uses one working disk with the system partition and if thats a ssd the boot will be faster

you could compare the timecodes in dmesg log to find out where the start process might be hold back, compare a 2min wit a longer and maybe you will see something

 

maybe disable ram compression in dsm?

 

 

Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.