p33ps 0 · ID: 1 Posted April 13, 2015 Hi, Currently I am using NOIP service to access to my machine, but I'd like to use QuickConnect to check if it's necessary for me. I've an original serialnumber so I think I can use it if I change it into my HP Gen8, but I don't know exactly where should I change it. Could someone help me? Another question is how to change the MAC address to the original one. I hope someone can help me with this too Thanks a lot! Share this post Link to post Share on other sites
holybabel 0 · ID: 2 Posted April 13, 2015 You can change both (SN and MAC) in the isolinux.cfg file from xpenoboot. sn=??? For mac i think it is mac1=??? Share this post Link to post Share on other sites
p33ps 0 · ID: 3 Posted April 13, 2015 You can change both (SN and MAC) in the isolinux.cfg file from xpenoboot.sn=??? For mac i think it is mac1=??? I guess with this I will use QuickConnect an WOL without problems, right? Share this post Link to post Share on other sites
Bob the Builder 84 · ID: 4 Posted April 13, 2015 (edited) off Edited August 3, 2015 by Guest Share this post Link to post Share on other sites
p33ps 0 · ID: 5 Posted April 23, 2015 ready S/N and MAC Adress for DS3615xs here One alternative is TUNNL Howto: here(ru) and here(de) That generator means that I can put the S/N + any MAC Address in the isolinux.cfg file and it should be working? Sorry for the late reply. Share this post Link to post Share on other sites
