Jump to content
XPEnology Community

NICs were not able to be seen on DSM setting


r00tAndr0id

Recommended Posts

Hi All.

 

I have a DSM 6.2.3 installed on baremetal HPE ML10 Gen9 with Mellanox CX3 dual port NIC.

After a suddenly power outage, I can't connect to my DSM.

I plugged a cable back to onboard NIC then I can connect to my NAS via DHCP IP, but only 1 NIC shows in DSM setting.

So I disabled the onboard NIC, then I can connect to the NAS by CX3 first port IP, the second port doesn't show in DSM setting

But all NIC can be identified by ifconfig and they can get IP from DHCP server.

Any suggestions to resolve this?  Thanks!

 

Edited by r00tAndr0id
Link to comment
Share on other sites

from the symptoms it sounds like you use 1.04b/918+ (your 6th gen cpu would allow this) that has a default limit of 2 nic's and the config was reset to defaults

you would have needed to manually change this from its default maxlanport="2" to something higher to get 3 ports working

/etc/synoinfo.conf

/etc.defaults/synoinfo.conf

read this to check and change it (again)

https://xpenology.com/forum/topic/12679-progress-of-62-loader/?do=findComment&comment=92682

 

the network config is stored here

 /etc/sysconfig/network-scripts

but i dont think that would be the problem

the default files can be fount in the full dsm *.pat file, open it with 7zip, for checking whats the default of the original system as it comes from synology

*_25426.pat\hda1.tgz\hda1\etc.defaults\sysconfig\network-scripts\

same goes for the default synoinfo.conf *_25426.pat\hda1.tgz\hda1\etc.defaults\synoinfo.conf

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...