brannigan Posted May 17, 2013 Share #1 Posted May 17, 2013 hello, Sorry for my english. I have a motherboard jetway NC9C with ATOM 455 mono-core with HT. http://www.jetway.com.tw/jw/ipcboard_vi ... C9C-455-LF This motherboard have 2x Realtek RTL8111E PCI-E Gigabit Ethernet LAN But i had this daughter board with 3 Lan http://www.jetway.com.tw/jw/ipcboard_vi ... 3RTLANG-LF When i finish my installation of XPEnology with the last build. The soft see 2 nic , the nic of the motherboard but i can see the 3 of the daughter board. Do you have a solution? It is for doing a teaming with the all 5 nic. Thank you a lot. Link to comment Share on other sites More sharing options...
odie82544 Posted May 17, 2013 Share #2 Posted May 17, 2013 Your LOM and daughter board LAN chip need to install mii.ko, r8168.ko and r8169.ko. The r8169 driver are older, but not fully support r8168, if load the r8169 first, than some r8168 chip can't work properly. For fix your issue, the driver load sequence should be: 1.mii.ko 2.r8168.ko 3.r8169.ko But from my view, the daughter board with LOM x3 won't improve the LAN performance too much if you are target for this. Because most r8169 are for PCI base chip, the total Max. bandwidth for PCI-33 bus are only 133MB/sec. Link to comment Share on other sites More sharing options...
atomi23 Posted May 17, 2013 Share #3 Posted May 17, 2013 looks that the doughtcard have the RealTek RTL8110S chipset thats not supportet ,did you dry the +++ version with more drivers inside ? Link to comment Share on other sites More sharing options...
brannigan Posted May 17, 2013 Author Share #4 Posted May 17, 2013 thank you for reply, I will test with the version +++ I don't know the speed of the gpio header. Link to comment Share on other sites More sharing options...
Recommended Posts