Popeye-DR Posted February 19, 2020 Share #1 Posted February 19, 2020 My system just stop communicating, and I thought that it was my MELLANOX CONNECTX-2 card. I did some troubleshooting, and the NIC is on a good conditions, but not recognized on Xpenology. I do not know if I should redo my USB, and everything that is save or configured, might be gone. Or, just change the extra files for a different ones. Now I am connected to it via the main motherboard NIC. My main concerns is that If I change any configurations on the USB, will I loose everything? Note: I am using 918+ Xpenology USB Quote Link to comment Share on other sites More sharing options...
IG-88 Posted February 20, 2020 Share #2 Posted February 20, 2020 (edited) was the system updated to dsm 6.2.2? Edited February 20, 2020 by IG-88 Quote Link to comment Share on other sites More sharing options...
Popeye-DR Posted February 20, 2020 Author Share #3 Posted February 20, 2020 Yes. when I used Synology Assistance app, it has version 6.2.2-24922 Quote Link to comment Share on other sites More sharing options...
IG-88 Posted February 20, 2020 Share #4 Posted February 20, 2020 and did you use the new 6.2.2 capable drivers from here? (i guess not) please reread you initial post and you discretion of the problem - you not even mention that you updated and lost connection after that read the following and you should be able to fix it by just copying the extra/extra2 to you (updated) usb drive Quote Link to comment Share on other sites More sharing options...
Popeye-DR Posted February 25, 2020 Author Share #5 Posted February 25, 2020 The extra918plus_v0.8_std worked. I was able to see the my MELLANOX CONNECTX-2 card, and no loose any data. On 2/19/2020 at 4:55 PM, Popeye-DR said: My system just stop communicating, and I thought that it was my MELLANOX CONNECTX-2 card. I did some troubleshooting, and the NIC is on a good conditions, but not recognized on Xpenology. I do not know if I should redo my USB, and everything that is save or configured, might be gone. Or, just change the extra files for a different ones. Now I am connected to it via the main motherboard NIC. My main concerns is that If I change any configurations on the USB, will I loose everything? Note: I am using 918+ Xpenology USB My concern was that if I made any alteration to my USB, if I would loose everything. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.