Jump to content
XPEnology Community
  • 0

How to set up and use a serial console


tdse13

Question

I want to use a serial console with a Asutek J3455. I connect a USB to serial converter to the J3455 GND to GND, TX to RX, RX to TX. And I connect the USB port to my MacBook. In a VM I have also access to Windows 10. Serial Port on the the J3455 is enabled in Bios.

 

My queiston: What are the next steps to read the output? I tried with Putty and with the Mac terminal without success. Any idea? Thank you.

Edited by tdse13
Link to comment
Share on other sites

9 answers to this question

Recommended Posts

  • 0

Yes, this one I need as well. However, I checked all pins on "your" adapter and my adapter (FTDI Adapter FT232RL - see attached foto) has the same pins. Do I really need all of them? The pins wich are easily available are: RXD, TXD, DTR, GND, CTS. DCD, RTS, and RI need to be soldered. Do  I really need the last 3 Pins? Thank you. 

71iKvZ0wD2L._SL1500_.jpg

Edited by tdse13
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
×
×
  • Create New...