Muzzy Posted July 23, 2019 Share #1 Posted July 23, 2019 Hi, I have a problem with running any loader (1.02b, 1.03b, 1.04b) on this board. I set up vid and pid according to the flash drive, sataportpam = 22, mac and serial number, but after booting from flash, I don't see the machine through synology assistant. On the router I see that the ip has been assigned. Is there needed to set something special in the bios of the board? I turned off C1E support, set the drives to ide. I also tried to add a network card (Intel), but that didn't help. Thanks a lot Quote Link to comment Share on other sites More sharing options...
unmesh Posted September 7, 2019 Share #2 Posted September 7, 2019 (edited) I was able to run DSM DS918+ 6.2.1 Update 6 over Jun's Mod V1.04b loader successfully though I don't run it all the time. Edited September 7, 2019 by unmesh Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.