SerpensAlatus Posted July 7, 2019 Share #1 Posted July 7, 2019 Hi, today my NAS won't start anymore. It boots but stops before there is a network connection. Is there a console or something so that i can where it stucks? I use Junes Bootloader 1.04b für the 918+ Thanks in advance Serpens. Quote Link to comment Share on other sites More sharing options...
bearcat Posted July 7, 2019 Share #2 Posted July 7, 2019 @SerpensAlatus did you by any chance update your NAS? Quote Link to comment Share on other sites More sharing options...
SerpensAlatus Posted July 7, 2019 Author Share #3 Posted July 7, 2019 Maybe. I restarted the NAS and it was dead. You think about Problems with the NIC, right ? Regards Volker Quote Link to comment Share on other sites More sharing options...
jensmander Posted July 8, 2019 Share #4 Posted July 8, 2019 In most cases this happens when you haven’t disabled the automatic installation of updates. If you have a s-ata port left you could try the following: - shut down your nas - unplug your current drives - if you have different drive sizes write down which drive is connected to each s-ata port - add a blank hdd to your free port - power up the nas and do a fresh install on the blank hdd, follow the initial setup and shut the nas down once it’s complete - reconnect your old drives and start the system again, you should see your raid/volumes now again Or you can add an additional NIC (Intel) which is supported by the 918+ loader. 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.