Olegin Posted December 18, 2018 Share #1 Posted December 18, 2018 Very interesting trick was done by our comrad deloza. If on the motherboard with intel or realtek NIK's for some reason after installation of the loader xpen is not looked for in a network, it is possible to try the following: - using the newly created bootable USB drive to install xpen on the hardware on which it guaranteed starts; - move the flash drive and the HDD where you installed xpen to the mb on which the installation process does not start; - power on and possibly DSM will start... Try and report, it is very interesting if anybody else will do it. Quote Link to comment Share on other sites More sharing options...
yuwave Posted December 19, 2018 Share #2 Posted December 19, 2018 Does it prove feasible? Quote Link to comment Share on other sites More sharing options...
Olegin Posted December 19, 2018 Author Share #3 Posted December 19, 2018 No, just the possibility. Quote Link to comment Share on other sites More sharing options...
sbv3000 Posted December 19, 2018 Share #4 Posted December 19, 2018 this might work if the drivers installed by DSM are then added to the usb Quote Link to comment Share on other sites More sharing options...
Olegin Posted December 19, 2018 Author Share #5 Posted December 19, 2018 It seems to me that it is not so. Most likely, the installation process loads the drivers from the boot loader, and if the DSM is already installed, its drivers are loaded at startup. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.