Jump to content
XPEnology Community

DSM 6.2 unstable network


jorgen

Recommended Posts

Hi,
after updating to 6.2 on my Gigabyte GA-170N based pc, I see that all packages are stopped, the DSM Update status is red and fails to connect, under Network.General all fields are blank, and under Network interface it may or may not show my NICs. even though it does not reach the internet and no NICs are listed I can still log into DSM via the browser, and sometimes I am able to access the shares from another pc.

 

The motherboard has Dual Intel GbE LAN, and this the output from putty listing drivers:

lspci -k | grep 'Kernel driver'
        Kernel driver in use: i915
        Kernel driver in use: xhci_hcd
        Kernel driver in use: ahci
        Kernel driver in use: pcieport
        Kernel driver in use: pcieport
        Kernel driver in use: pcieport
        Kernel driver in use: pcieport
        Kernel driver in use: pcieport
        Kernel driver in use: pcieport
        Kernel driver in use: i801_smbus
        Kernel driver in use: e1000e
        Kernel driver in use: igb

 

I've tried replacing the extra.lzma 1.03a2 with the one in extra918plus_v0.2, but no difference.

 

Anybody got a clue what may cause this?

 

Thanks,

j

Link to comment
Share on other sites

the 918+ is limited to 2 lan ports without mod

there is e1000e and igb so two different drivers, if there is a pcie nic try to remove it, if teh board has 2 different lan chips the try to disable one, test switch to disable the other and test again

i've tested both drivers on a skylake system

 

also try your usb flash drive and a single empty disk with a fresh 918+ install, maybe some kind of upgrade problem (bonding and maybe mtu size othe then 1500 are involved?)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...