Jump to content
XPEnology Community

DS916+ Quad NIC - only 2 of 4 interfaces show up


prodigyblur

Recommended Posts

Hi All,

 

I installed the 916+ on bare metal a few days back and everything seems to work well except for my HP NC364T quad NIC which has Two Intel 82571EB chips. It uses the e1000e driver and each interface has a mac address, for which all are supplied in the GRUB boot cfg. "Ip addr" and dmesg both show all 4 interfaces, but only eth0 and eth1 are "up". Eth0 and eth1 are present in /etc/sysconfig/network-scripts/ and I can create eth2 and eth3 in this folder, do a "ifconfig up" to bring the interfaces up and then they show up in DSM gui, and are useable. Upon reboot the entries in network-scripts are lost (eth2 and 3) and they no longer show up in the gui. I can create a script to automate this on every startup but figured I would check here for better solutions. Any ideas?

 

I used the 1.02b loader and my cpu is a i5 haswell, b85m-e mobo (realtek NIC is disabled in bios), 16gb ram.

 

Thanks

Link to comment
Share on other sites

  • 10 months later...

I have a question,  how do I change the default 169.x.x.x for LAN3 and LAN4 since now they come up using this fix? They are supposed to be DHCP, but neither one takes my 192.x.x.x subnet. Which config file is this under?

Edited by mr9v9
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...