I have a problem and I don't know if it is loader related. I'm using DS920+, with DS918+ I can't get past SATA errors when installing.
I have 1 HDD that I migrated from 6.2.2 to 7.1 and is showing in Storage manager under HDD/SSD.
Now I added second drive that was also from other NAS and it is now showing at all.
I wiped it, cleaned partition and all. Still not showing under HDD/SSD, only Drive 1.
If I ssh into NAS and check with fdisk -l I can see both drives.
1st drive that is installed, this one is showing
Disk /dev/sata1: 3.7 TiB, 4000787030016 bytes, 7814037168 sectors
Disk model: WD40PURX-64NZ6Y0
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disklabel type: gpt
Disk identifier: 05A24373-37C7-4412-8FE7-7229DD76D6D1
Device Start End Sectors Size Type
/dev/sata1p1 2048 4982527 4980480 2.4G Linux RAID
/dev/sata1p2 4982528 9176831 4194304 2G Linux RAID
/dev/sata1p3 9437184 7813832351 7804395168 3.6T Linux RAID
2nd drive that I can't see
Disk /dev/sata2: 1.8 TiB, 2000398934016 bytes, 3907029168 sectors
Disk model: WD20PURX-64P6ZY0
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes
Disklabel type: gpt
Disk identifier: 8F3CA9AA-B131-42C8-A4F3-E69D78CDF90D
Device Start End Sectors Size Type
/dev/sata2p1 2048 3907029134 3907027087 1.8T Linux filesystem
Thanks