wifi75

hello for cpu scaling Governor, what it the best choice as below?

I used your same patch file, but then you have to reboot after running the script?

hello what is the script to run?

is there a patch for advanced media extension?

thanks again for all the replies. I thought baremetal was more stable than a vm on proxmox. Greetings

OK all clear! but is it better to install the loader on a usb drive and run DSM natively on my pc, without using proxmox?

no I didn't stop DSM during the restore! sata 0 is my arpl, in fact it is 500Mb, while sata 1 of 32 Gb is disk 1 of dsm, however the problem occurred during the recovery and not during the backup. While recovering backup , the proxmox server it seemed heavy, yet the cpu was not at around 24% where DSM is installed is the applications for the network card I set the virtio.

Hello Orfeo thank you for reply! the problem does not appear when i create a backup of any vm, but when i restore any vm. I backup the VMs directly from the proxmox gui. here is my DSM vm configuration:

Hello everybody, I installed promox 7.2 on amd AMD Ryzen 5 5600G with Radeon Graphics. Proxmox is installed on two sata raid zfs disks. It has happened several times that while restoring a vm from a backup, the vm where DSM is installed crashes, and shuts down. while the other two VMs running Homeassistant and a weather server work without problems. I can't figure out why the dsm vm crashes, resulting in loss of disk data on which various dsm applications are installed. Where do you think I could start from to understand what makes DSM insyable on a vm in proxmox? Note. during the recovery phase of a vm, proxmox almost always becomes unreachable. I hope someone can help me 🙂

hello I'm trying your loader, could you also make a guide for proxmox? what is Synocode Patch ? and nvme (NVMe als Cache)?

i asked this question because my disks crashed and i don't understand why, the proxmox sevrer never shut down, this morning i found pool 1 in raid one with the message that they were read only. on reboot it appeared that pool 1 and poll2 two crashed ... now I can't access my data anymore, and on pool 2 I also had a backup ..

Volume 3 it is single disk with backup inside

@pocopicoHello, on proxmox is it better to add the disks directly to the nas or better to add it to proxmox and then to the vm?

Hello what is the command for atthash .img file as sata disk?

Hello, I hope someone can help me, it's the second time i lose data. i installed automated redpill on proxmox, this morning i had some disks in read only, also i have a backup s internal disk. In practice, after restarting the nas this error appeared: what can I do? does termional can I run some command to scan the disks?