wpyung

New Members
  • Content Count

    5
  • Joined

  • Last visited

Community Reputation

0 Neutral

About wpyung

  • Rank
    Newbie
  1. I never managed to resolve this. A total reinstall made things worse - the install never completed In the end I installed Ubuntu onto the hard disks and recovered my data from backup disks...
  2. this is the same problem I have now. https://community.synology.com/enu/forum/1/post/134179?page=1&reply=425396 I think I already have the correct lzma file and BIOS Any ideas ?
  3. have confirmed I am running 6.2.2 24922 by looking at the VERSION file. So How do I upgrade from command line ? I am on the network with access to the Internet.
  4. the NIC is working, just not the WebGUI How do I check which version of DSM I am running and do the upgrade, from the command line ? Thanks Peter
  5. On an HP N40L I followed the promptsand upgraded from 5.2 to 6... Using the old boot stick the system would not boot giving messages about files not found in /tmp After a lot of grief, to make a new XPENology boot stick I now get the problem below. I have used the loader synoboot 6.2 put in new files on the 2nd partition (from DSM_DS3615xs_24922.pat), set the pid, vid, serial number (as it was on 5.2) and MAC address. Then upgraded the BIOS and disabled the C1E. Now at last the RAID array is accessed and the system is on the network with its original IP