Jump to content
XPEnology Community

jacksonsystems

Rookie
  • Posts

    3
  • Joined

  • Last visited

jacksonsystems's Achievements

Newbie

Newbie (1/7)

0

Reputation

  1. Ah ok I see in PCI devices that I can see the Chipset etc and it will allow me to pass that through - I dont see LSI though. I shall do some playing around and see what I can do! Ill check out that link yo posted, thanks.
  2. OK so the best approach being then if I pass the disks hrough using JBOD on the raid. Then attahc them to the DSM VM direct through ESXI? Not sure what the RDM profiel is?!
  3. Hi all I have ESXI running on my Fujitsu TX2540 M1 - Server has built in LSI Raid on motherboard. I have configured 4 2.73 TB Drives in RAID10+1. ESXI installed on an SSD on SATA0 on the motherboard. ESXI is installed and up and running but for some reason even though the drives are configured in RAID (RAID status says 5.42TB of Spac across member disks) ESXI is seeing them as individual disks - I as expecting to see the 5.42TB RAID Volume. I have created a storage pool adding in all of the disks and attached that to my Xepenology VM and it is working fine.... but it worries me that the drives are not redundant. As far as I can see the LSI controller is supported. Anyone else had issues? Any ideas on how I can get the volume into ESXI raher than seperate disks - I realize ths may be a specific ESXI issue and not Xpenology. Thanks
×
×
  • Create New...