ravi

Once the install is complete, do you remove the usb and boot it from the hard drive?

Just one thought I am using a sandisk usb, is it fussy about which usb drives you use? It boots OK, but never appears in DSAssistant...

I used the DS3615xs image, and the serial for that model. The intel nic was an NC360T previously used in an xpenology N54L box. I entered both mac addresses without the colons. As I mentioned the nic works fine with windows 10. I was wondering if I have to edit the sata port entry as the N54L has both the raid adapter and the standard sata connector. With the modded bios I had the connector for the cd drive connected to a ssd boot drive under windows. It up shows as the 5th drive in the sata chain. I was thinking that I could install 6.1 with the native nic enabled and remove the intel NC360T and use the 1.02b loader. Bit frustrated with getting the system to work! Thanks for any tips.

I plugged them both in to make sure... could that have caused a problem?

I am trying to get 6.2 running on my microserver, using loader 1.30b. I have N54L it is running moded bios, C1E disabled, Intel dual nic. Intenral nic disabled. Just one drive in the first raid port. I have created the usb drive with the ammended grub.cfg but when it boots from the usb it does not appear in synology assistant, and when I look in the router no sign of any connections. It all works fine running windows 10, both nics show up. Bit miffed, any suggestions? Thanks